User guide

NO DISPENSER DETECTED – The dispenser is the mechanism that contains the

output trays, transfer slides, and dispenser circuit board. The circuit board detects

discs as they move down the transfer slide. Check the cable connection to the

dispenser circuit board or connection to the internal circuit board.

OUTPUT TRAY X OUTPUT FAIL – A disc was dropped into the #X output tray

and the tray sensor detected that the disc did not slide past the tray sensor. This stops

the autoloader from further movement.

SUPPLY BIN NO MEDIA – The supply bin is empty. If the supply bin is not empty,

run diagnostics test 03 to re-calibrate the lift arm movement.

Everest Printer Errors

Possible error messages from the Everest Printer that could display on the Endeavor

operator panel:

EVEREST PRINTER #1 NOT LOCKED – Open the Everest printer cover and

close latch #1.

EVEREST PRINTER #2 NOT LOCKED – Open the Everest printer cover and

close latch #2.

EVEREST PRINTER #3 NOT LOCKED – Open the Everest printer cover and

close latch #3.

EVEREST PRINTER CLAMPING FAILURE – Check the printer alignment so the

discs can be clamped properly on the print drawer.

EVEREST PRINTER CLOSING ERROR – The print drawer could not close. This

is usually because the drawer was catching on something. Check the alignment of the

printer and look for obstructions.

EVEREST PRINTER COVER OPEN – Close the Everest printer cover.

EVEREST PRINTER DATA ERROR – Label file could be corrupt or the label file

was built by the wrong print driver. Check selected print driver, rebuilt the label, and

try again.

EVEREST PRINT DRAWER ENCODER – Send the Everest Printer to the factory

for service.

EVEREST PRINTER HALOGEN LAMP OUT – Halogen lamp in the Everest

printer must be replaced.

EVEREST PRINTER INK RIBBON GONE – The print ribbon is not installed and

a ribbon must be installed.

EVEREST PRINTER INK RIBBON SENSR – Clean the print ribbon sensor or

send the printer to the factory for service.

EVEREST PRINTER LOWER P.H. ERROR – Send the Everest Printer to the

factory for service.

EVEREST PRINTER NO MEDIA – The lift arm could not pick a disc off the

printer. There was not a disc on the print pad or the printer is not aligned to the

gripper fingers. The gripper solenoid may not be working or it needs adjustment.

EVEREST PRINTER OPENING ERROR – The print drawer could not open or the

drawer was hitting something. Check the alignment of the printer.