User guide

of the tray with tray #1 located at the top. Select this test and place a disc in the tray

and the panel displays “Blocked”. Remove the disc from the tray and the panel shows

“Unblocked”.

Press the operator button to exit the test.

 Tray Sensor Output Tray

10 – Output Tray 2 Diagnostic

See diagnostic test #9.

11 – Output Tray 3 Diagnostic

See diagnostic test #9.

12 – Output Tray 4 Diagnostic

See diagnostic test #9.

13 – Output Tray 5 Diagnostic

See diagnostic test #9.

14 – Exit Test Mode Diagnostics

This is not a test, but it is used to exit the diagnostic mode and returns to the normal

operation mode.

Operator Panel Error Messages

CLAMP FAILURE – the Everest Printer tried to clamp a disc but it failed. Check the

alignment of the printer to the gripper fingers.

ENDEAVOR PAUSED CHECK DOOR/BIN – Endeavor stopped all movements

because the door is open.

EVEREST PRINTER … – For an Everest Printer error, go to the “Everest Printer

Error” section to locate the error and possible solution.

NO PRINTER DETECTED – The printer’s serial cable is not connected to the

autoloader, or the printer has no power. Check the cabling and the mode switch

setting. The mode switch should be set to 0 or 1.