User guide

8. If the disc is not centered side-to-side on the print pad, continue to step 9. You can

see if the disc is not centered by observing the gap between the disc and the edges

as shown by the arrows. If the side-to-side alignment is good, go to step 10.

9. To perform the side-to-side alignment procedure, loosen the two Torx side-to-side

screws. Slide the printer, NOT the drawer, in small increments until the side

edges of the disc and print pad are aligned. Then tighten the two Torx side-to-side

screws. (The picture below shows the printer drawer closed so the adjustment

screws can be seen.)

 Front-to-Back Alignment Screw Side-to-Side Alignment Screws