User guide

Chapter 2 – User Operations

Introduction

This chapter describes Endeavor setup, including:

• Loading Discs

• Installing Ribbons

• Powering on Endeavor

• Power-Up Sequence Display Messages

• Remove Discs from Output Tray

• Removing and Installing the Front Panel

Loading Discs

You can load up to 50 discs in the supply bin. Use thermal printable discs compatible

with the Everest II Printer.

1. Open the autoloader door.

2. Hold the discs by the outer edge so you do not put fingerprints on either the top or

the bottom surface and place them in the supply bin. Fingerprints on the top can

affect printing.

Ensure that the discs are oriented correctly. There is an extruded ridge called a

stacking ring that can barely be seen, but can be felt, on one side of a disc. This

ridge distinguishes the bottom of the disc. Some DVD-R discs have a stacking ring

on both sides. Be sure to place the recording side facing down.

 Stacking Ring

Orient the discs so the top of the disc is facing upward as shown above.

5. Close the door.