User guide

Centering the Label

There are two ways to center the label. If the printer has a microparallel cable

connection, and you have the Rimage serial cable, you can program the offsets. If you

do not have the serial cable, you can adjust the print position by changing the top and

bottom margins.

1. In the CD Designer application, select Page Setup.

2. Select the Margins tab.

3. Change the left and top margins. Increase the top margin to bring the printed

label downward. Increase the left margin to move the label toward the right.

4. Select OK to save the changes to the label.

5. Print another label to verify the proper print position.

Cleaning the Printhead

Clean the printhead at every ribbon change, or more often if streaks start appearing or

the ribbon has torn.

The following procedure to clean the printhead requires the CD-R cleaning kit

(210555-001). This kit includes the necessary cleaning pads and solution. Contact

your local Value Added Reseller for the cleaning kit.

To Clean the Printhead

1. Power down the printer, then remove the cover.

2. Remove the ribbon. See “Installing a Print Ribbon” on page 17, if needed.

3. Hold down the Unit Attention button and power up the CD printer. Release the

button when the Missing CD LED flashes.

4. Remove the adhesive backing from the cleaning pad and adhere the pad to a CD.

5. Place the cleaning pad and CD on the drawer as shown in the figure below.

6. Press the pad down over the sensor as shown in the next figure.

7. Place 5 drops of cleaning solution on the cleaning pad as shown in the figure

below.