User guide

Rimage AutoPrinter II

4. To perform the front to back
alignment procedure, turn
the Front to Back
Alignment Screw until the
disc hangs over the front
edge of the Print Pad by
0.010” – 0.015” (0.38 mm).
Tip: You can use the T25
Torx driver or a 5/32” Allen
wrench to turn the Front to
Back Alignment Screw.
5. After the printer is aligned, raise the Lift Arm out of the way of the Print Drawer.
6. Close the Print Drawer by pressing the Unit Attention Button.
7. To release the disc from the Gripper, hold the disc while pressing the Disc Release Button.
Setting the Prism printer to AutoPrinter mode
If the Prism Activity light does NOT continually flash at a slow rate, you must set your Prism
printer to the AutoPrinter mode for it to work with the AutoPrism autoloader.
1. Ensure that the Prism printer is installed on the AutoPrinter II and it is cabled correctly.


Note: If the Activity and Error lights flash together, this indicates that there is a
communication failure between the Prism printer and the AutoPrinter autoloader. If this
occurs, verify that the printer control cable is properly connected between the Prism printer
and the autoloader, and that the autoloader is powered on.
2. Verify that the power switch for the Prism printer is set to the ON position.
Note: It is unnecessary to power off the Prism printer since the switch on the autoloader
controls its power source.
3. Power on the AutoPrism using the autoloader power switch.
4. With no disc on the Prism print drawer, press the Prism Unit Attention button to open or close
the drawer and hold it for about 5 seconds. You will hear a beep or see the Prism Activity
light turn on and remain lit.
5. Release the Unit Attention button. The Prism Activity light will continue to flash slowly as long
as the Prism printer is in AutoPrinter mode.
10 110656_G