User guide

Operate the AutoPrinter II
b. To place a disc in the
Gripper, press the disc
up into the Gripper
while pressing the Disc
Release Button.
c. Release the button. The
Gripper holds the disc.
d. To open the print
drawer, press the Unit
Attention Button.
e. Slowly, move the Lift
Arm down until the disc
is just touching the Print
Pad.
3. Check the side to side
alignment.
a. Observe the left edge of
the disc and the raised
edges of the Print Pad
as shown by the arrows.
b. If the disc edge is not
aligned to the edge of
the Print Pad, loosen
the two Side to Side
Alignment Screws.
c. Slide the printer, NOT
the printer drawer, until
the edges are aligned.
d. Tighten the two Side to
Side Alignment
Screws.
110656_G 9