User guide

Operate the AutoPrinter II
Aligning the Everest II printer
After installing the printer, or if discs are not placed on the printer properly, the printer may need
an alignment to the gripper arm.
Required Tool: T25 Torx driver.
1. Prepare the AutoPrinter for alignment.
a. Power on the AutoEverest by pressing the AutoEverest power switch. Wait for the unit to
complete the warm-up initialization, indicated by the Activity LED coming on. The Everest
printer takes about 2 minutes to complete the initialization.
b. If the lift arm is not at the top of the AutoPrinter, manually move the lift arm to the top.
c. To place a disc in the
gripper, press the disc
up into the gripper while
pressing the Disc
Release Button.
d. Release the button. The
Gripper holds the disc.
e. To open the print
drawer, press the
Printer button.
f. Slowly move the lift arm
down until the disc is
just touching the Print
Pad.
2. Check the side to side
alignment.
a. Observe the gap
between the edge of the
disc and the raised
edges of the Print Pad
as shown by the arrows.
110656_G 7