User guide

Maintain the DLN5200/DL5200

The procedures in this section will help keep your DLN5200/DL5200 in optimum operating

condition.

Preventive maintenance schedule

Maintenance Procedure Schedule

Once a week. Using a damp, lint free cloth, remove dust from

the autoloader and surrounding work area.

Cleaning the Rimage

DLN5200/DL5200

On installation and as needed. Refer to the instructions

below.

Aligning the Everest printer

When the Everest printer is installed or replace, you may need to align it to the lift arm.

# Tools Needed: Torx T25 driver

Before you begin:

Power on the Rimage DLN5200/DL5200 autoloader. Wait for the unit to initialize.

 Note: The Everest printer takes 2 to 3 minutes to complete the initialization.

1. Select Diagnostic test 4 - jog lift diagnostic.

a. Press and hold the operator button to place the unit in diagnostics mode. The operator

panel indicates when to release the button.

b. When the operator panel displays 01 CYCLE OUTPUTS DIAGNOSTIC, press the

operator button four times and hold on the fourth press. This selects the JOG LIFT

DIAGNOSTIC TEST. The lift arm moves down toward the print drawer as the printer

tray opens.

c. When the operator panel prompts you to place a disc, place a disc on the print pad.

2. Check the printer alignment.

Printer Tra

a. Press the operator button to move

the lift arm closer to the print pad.

b. Press the operator button again

and the lift arm moves down and

picks up the disc.

Lift Arm

Disc

Print Pad

110768_E 11