User guide

Rimage DLN5200/DL5200

12 110768_D

Maintain the DLN5200/DL5200

The procedures in this section will help keep your DLN5200/DL5200 in optimum operating

condition.

Preventive maintenance schedule

Maintenance Procedure Schedule

Cleaning the Rimage

DLN5200/DL5200

Once a week. Using a damp, lint free cloth, remove dust from

the autoloader and surrounding work area.

Aligning the Everest printer On installation and as needed. Refer to the instructions

below.

Aligning the Everest printer

When the Everest printer is installed, it may need to be aligned to the lift arm.

Tools Needed: T25 Torx driver

Before you begin:

Power on the Rimage DLN5200/DL5200 autoloader. Wait for the unit to initialize.

 Note: The Everest printer takes 2 to 3 minutes to complete the initialization.

1. Select Diagnostic 4, jog lift diagnostic.

a. Press and hold the operator button to place the unit in diagnostics mode. The operator

panel indicates when to release the button.

b. When the operator panel displays 01 CYCLE OUTPUTS DIAGNOSTIC, press the

operator button four times and hold on the fourth press. This selects the JOG LIFT

DIAGNOSTIC TEST. The lift arm moves down toward the print drawer as the print

drawer opens.

c. When the operator panel prompts you to place a disc, place a disc on the print pad.

2. Check the printer alignment.

a. Press the operator button to move

the lift arm closer to the print pad.

b. Press the operator button again

and the lift arm moves down and

picks up the disc.

c. Manually rotate the lead screw

counterclockwise to move the lift arm

down to the print pad.

Lift Arm

Disc

Print Pad

Print Drawe