User guide

Identify the parts of the Rimage DLN5200/DL5200
Output trays
The Rimage DLN5200/DL5200 is configured
with five output trays and an output bin. When
a disc is recorded and printed, the lift arm
moves the disc to the output bin or one of the
output trays. The disc slides out to the end of
the tray. The sensor located on each output
tray detects if a disc is in the output tray. The
output trays are numbered 1 - 5, with 1
located at the top.
Output bin
The output bin receives finished and/or failed
discs. The output bin holds up to 75 discs.
To remove discs from the output bin, hold
the output bin with one hand while moving the
bin latch up and then lower the bin.
Output
Trays
Out
p
ut Bin
 Note: Each time you fill the supply bin,
remove the completed discs from the
output bin so the output bin does not
become full.
To lower the output bin, hold the output bin
while lifting the latch. Then lower the output
bin.
To raise the output bin into position, lift the
output bin and then pull the bin latch down to
lock it in place.
Bin Latch
p Caution: Do not use the latch to raise the
output bin!
110768_D 5