User guide

Rimage DLN5200/DL5200
4 110768_D
Operator panel
The operator panel has a two-line LCD
display that informs you of operations or any
conditions that require resolution.
The Rimage DLN5200 displays the name of
the embedded PC or product name after it
initializes. The computer name is displayed by
default. This is helpful in identifying the
embedded PC on the network. Refer to the
Gemini Utilities section on page
15 to see
other options.
Operator Panel
Operator button
The operator button is a push button used to
open and close the print drawer. The operator
button is only accessed by removing the front
panel.
Press the operator button to open the print
drawer. Press it again to close the print
drawer.
O
p
erator Panel
O
p
erator Button
Beeper
The Rimage DLN5200/DL5200 has a beeper that sounds when user intervention is required.
Read the condition on the operator panel or at the client application and take appropriate action
to correct the problem. To stop the beeping, open the supply door.
To change the number of beeps or to disable the beeper, refer to the
Enabling the beeper section
on page
15.
Lift arm
The lift arm picks and transports the discs.
There are three gripper fingers, located on the
underside of the lift arm, that hold the disc.
You can press a disc up onto the gripper
fingers to check printer alignment or for other
reasons. You can remove the disc by pulling
the disc down away from the lift arm.
Disc present sensor
The disc present sensor is depressed when a
disc is held by the gripper fingers. It is used to
detect the supply bin, recorder trays, or the
print drawer.
Lift Arm
Gripper
Fin
g
ers
Disc Present Sensor