Installation guide

Rimage 2000i™ Knowledge Base

6. Select Properties.

7. Change Startup Type from Automatic to Manual.

- If your 3 party software requires the bridge server, delete

c:\Rimage\Interfaces\pofile.pof and c:\Rimage\Interfaces \iofile.iof. Reboot the

computer.

ions in the order they are presented.

•

8. Click OK.

Reboot the computer.

Important!

The Production Server can not attach to the printer.

- Important! Try these solut

Reseat the USB cable.

1. Power off the 2000i.

2. Disconnect the USB ca

3. Connect the cable, en

ble.

suring that they are all secure.

•

e from the lift arm homing position to the

0i.

2. c

ays on the

il STARTING

o Note: Please ensure only a single disc is in the supply bin. Running diagnostic test 3

with more than one disc will cause the system to operate incorrectly.

4. Power on the 2000i.

Run diagnostic test 3.

This test uses one disc to calibrate the distanc

sup ly bin.

1. Remove all discs from the Rimage 200

Ac ess and select diagnostic test 3.

a. Press and hold the operator button until BUTTON DIAGNOSTICS displ

operator panel.

b. Release the operator button. The Rimage 2000i is in diagnostics mode.

c. Press the operator button three times and hold it on the third press.

3. When 03 CALIBRATE DIAGNOSTIC displays, hold the operator button unt

TEST RELEASE BUTTON displays.

Follow the instructions on the LCD: PLACE ONE DISC INTO SUPPLY BIN.