Installation guide

ManualsBrandsRimage ManualsComputer equipmentDesktop 2000i

Rimage 2000i™ Knowledge Base

The print has streaks.

- Important! Try these solutions in the order they are presented.

• Be sure you are using Rimage media. For more information, see

Rimage Media Kits.

• Clean or replace the ink cartridge. Refer to the Operate the Rimage 480i Printer section of

the

Rimage 480i Printer User Guide.

The print is smearing.

- Important! Try these solutions in the order they are presented.

• Be sure you are using Rimage media. For more information, see Rimage Media Kits

• Clean or replace the ink cartridge. Refer to the Operate the Rimage 480i Printer section of

the Rimage 480i Printer User Guide

The print is grainy.

- Important! Try these solutions in the order they are presented.

• Be sure you are using Rimage media. For more information, see

Rimage Media Kits

Replace the ink cartridge. Refer to

• the Operate the Rimage 480i Printer section of the

Rimage 480i Printer User Guide

•

The print is not masking or prints on the hub.

- Important! Try these solutions in the order they are presented.

If you are using OfficeNet Software, ensure that you have the latest Rimage Service Pack

installed. To find the latest service pack, refer to the

Downloads tab on the Support we

Navigate:

bsite.

www.rimage.com > Support > Desktop > 2000i. Select the Downloads tab.

• k settings in CD Designer or when printing PDF files.

 ces are saved with the label file and are

s button.

our discs have a stacking ring (raised area on the disc for stacking), you will

ake changes to the hub area setting appropriately.

Download the latest service pack.

Follow these steps to adjust the mas

Printing labels from CD Designer

Note: If using CD Designer, printing preferen

used instead of the printer driver setting

1. Open the label file with CD Designer.

2. Select Print. The Printer window opens.

3. Select the Document Propertie

4. Select the Mask Settings tab.

Make you

r changes to the inner and outer hub diameter under the Standard Area

settings.

 Note: If y

need to m