User guide

Important Information
110656_L 3
Safety and Compliance Information
20BSafety Precautions
This manual and the indications on the product allow proper and safe operation. The indication marks below help
protect you and other persons from injury, and equipment from damage.
I Warning! According to ANSI (American National Standards Institute) standards, a warning is used to
indicate situations that could result in bodily injury to personnel operating or maintaining the equipment.
Caution: Indicates that failure to observe this guideline could result in loss or damage to the equipment,
product, software, or data.
To ensure safety, please read the precautions in this document and familiarize yourself with their meaning before
using the equipment.
I
Warning!
Ÿ
Use of controls or adjustments or
performance of procedures other than those
specified herein may result in hazardous
radiant exposure.
Ÿ
Do not disassemble or use tools on a Rimage
printer. All service procedures should be
performed by a Rimage-authorized
technician, or sent in for Rimage-authorized
repair.
Ÿ
Do not service a Rimage printer with the
power cord plugged in the AC outlet.
Ÿ
The interior of a Rimage printer contains
sharp edges.
Ÿ
Do not use a Rimage printer if it is
overheating or an abnormal smell is detected.
This may result in a fire and an electric shock.
In case of heating or abnormal smell,
immediately disconnect the cable from the
outlet. Contact your Rimage-authorized
dealer for repairs.
Ÿ
The front bezel of the Rimage Everest™
printer can be opened by hand. Do not insert
your fingers.
Ÿ
Do not touch the heat roller in a Rimage
Everest printer.
Caution:
Ÿ
All equipment with AC line voltage, or low DC
voltages, such as switches, power supplies,
fuses, fans, non-stepper motors, must be
replaced with Rimage-approved components
to maintain the safety approval issued by UL.
Ÿ
Use only the supplied AC power cord. For
more information or to order a new power
cord, contact Rimage Customer Service.
Ÿ
This product is designed for an office
environment.
Ÿ
Allow sufficient free space for opening the
printer tray. Do not touch the printer tray while
it is moving.
Ÿ
If the side cover on the Rimage Everest
printer is opened while power is supplied, the
printer will stop. Do not reach into the printer
while it is operating. Do not attempt to bypass
the door interlock.
Ÿ
The Rimage Everest printer has no power
switch. Power is disconnected completely by
unplugging the cable. Rimage recommends
installing the printer in a position that allows
immediate disconnection of the power cable.
Always hold the plug when disconnecting the
cable from the outlet.
Ÿ
The Rimage Everest printer has a voltage
slide switch on the back of the unit. Before
use, make sure that it is set to the correct
voltage. Please do not use any voltage other
than 110VAC or 220VAC. This could result in
a fire and an electric shock.
Country-specific cautions for Wideband
Data Transmission systems; 2400-2483.5
MHz
Ÿ
France: Do not use outdoors.
Ÿ
Italy: If used outside of own premises,
general authorization is required.
Ÿ
Norway: This subsection does not apply for
the geographical area within a radius of 20km
from the centre of Ny-Alesund.