User guide

Rimage AutoPrinter™ User Guide

14 110656_L

b. If the disc is not centered side-to-side on

the print pad, adjust the alignment.

i. Use the Torx T25 screwdriver to

loosen the side-to-side alignment

screws (Qty. 2).

ii. Slide the printer until the side edges of

the disc and print pad are aligned.

Important! Slide the printer only.

Do not slide the printer tray.

iii. Tighten the side-to-side alignment

screws (Qty. 2).

& Tip: Tighten each screw in

increments to prevent shifting.

c. If the disc is not centered front-to-back on

the printer, adjust the alignment.

i. Use either a Torx T25 screwdriver or a

5/32″ Allen wrench to turn the front-to-

back alignment screw (Qty. 1).

ii. Make sure that the disc hangs over the

edge of the print pad by

0.010″ to 0.015″ (0.25 mm to

0.38 mm).

5. When the printer is aligned, slide the lift arm to the top of the AutoPrinter.

6. Press the printer operator button to close the printer tray.

7. Press the disc release button to release the disc from the lift arm.

& Tip: Place your hand under the disc to catch it.

The printer is aligned and the AutoPrinter is ready for use.

Side-to-Side Alignment Screws

Front-to-back

Alignment Screw

Pad

Gap