User guide

Rimage AutoPrinter™ User Guide
12 110656_L
4. Align the printer.
a. Slowly slide the lift arm down until the disc
just touches the print pad.
b. If the disc is not centered side-to-side on the
print pad, adjust the alignment.
i. Use the Torx T25 screwdriver to loosen
the side-to-side alignment screws
(Qty. 2).
ii. Slide the printer until the side edges of
the disc and print pad are aligned.
J
Important! Slide the printer only.
Do not slide the printer tray.
iii. Tighten the side-to-side alignment
screws (Qty. 2).
& Tip: Tighten each screw in
increments to prevent shifting.
c. If the disc is not centered front-to-back on
the print pad, adjust the printer alignment.
i. Use either a Torx T25 screwdriver or a
5/32″ Allen wrench to turn the front-to-
back alignment screw (Qty. 1).
ii. Make sure that there is a 1/16″ (1.5 mm)
gap between the front edge of the disc
and the raised edge of the print pad.
5. When the printer is aligned, slide the lift arm to the top of the AutoPrinter.
6. Press the printer operator button to close the printer tray.
7. Press the disc release button to release the disc from the lift arm.
& Tip: Place your hand under the disc to catch it.
The printer is aligned and the AutoPrinter is ready for use.
Printer
Operator
Button
Side-to-Side
Alignment
Print
Pad
Lift
Arm
Holding Pins
Front-to-back Alignment Screw
Side-to-Side
Alignment Screws
Front of
Printer
Gap
Print
Pad
Disc