User guide

Rimage AutoPrinter™ User Guide
10 110656_L
15BLoad and Unload Discs
You can load up to 100 discs per carousel bin. You may load discs in the bins before installing the carousel.
When the carousel is installed in the AutoPrinter, discs can be installed one bin at a time by using the following
procedure.
. Note: Use carousel bins 1, 2, and 3 to load blank discs. Bin 4 is used only for outputting completed discs.
22BLoad the Discs
1. Press the operator button to rotate the carousel and place bin 1, 2, or 3 in position to load discs.
2. Place blank discs in the bin.
J Important! Place the discs into the bin with the recording side facing down.
& Tip: Hold the discs by the outer edge so you do not put fingerprints on either the top or the bottom
surface of the discs. Fingerprints on the top of a disc can affect printing quality. Rimage recommends
wearing lint free gloves.
3. Repeat steps 1–2 until the bins 1, 2, and 3 are filled.
. Note: When bin 1 is empty, the AutoPrinter picks discs from bin 2. When bin 2 is empty, the AutoPrinter
picks discs from bin 3. After the AutoPrinter starts picking discs from bin 2 or 3, it continues picking
discs from that bin until it runs out of discs, it is powered off, or it is reset to pick from bin 1.
4. Reset the AutoPrinter. Refer to the
HReset the AutoPrinterH section below.
23BUnload the Discs
1. Press the operator button to rotate the carousel and place a bin in a position to unload discs.
2. Remove the discs from the bin.
3. Reset the AutoPrinter. Refer to the
HReset the AutoPrinterH section below.
24BReset the AutoPrinter
When the AutoPrinter is reset, it begins picking discs from bin 1, not the bin it was picking from before the reset.
Use the following procedure to reset the AutoPrinter.
1. Lift the carousel up so that the top support bearing comes out of the bearing guide. (Refer to the photo
on page 9.) The carousel present indicator light illuminates.
2. Set the carousel back down. The carousel present indicator light turns off and the AutoPrinter resets. When
the next print job is submitted, the AutoPrinter will start picking discs from bin 1.
16BSet Printing Preferences
Printing preferences allow you to set up your AutoPrinter to produce the best possible labels on your discs. Refer
to your Everest or Prism printer user guide for specific printing preferences instructions.