User guide

Rimage Amigo II
8 110654_F
PrismPlus printer
To align your PrismPlus printer, refer to the following instructions.
Required tools:
• T 25 Torx screwdriver
• 5/32” Allen wrench
1. To power on the Amigo II, press the PrismPlus power switch and the Amigo II power
switch.
2. Wait for the unit to complete the initialization.
3. Prepare the unit for alignment.
a. Manually move the lift arm to the top
of the Amigo II.
b. To place a disc in the lift arm, press the
disc up into the lift arm while pressing
the disc release button.
c. To open the print drawer, press the
printer button.
d. Close and re-open the door. This
releases the lift arm so you can
manually move it.
Lift
Arm
Gri
pp
e
r
Disc Release Button
4. Align the printer.
a. Slowly move the lift arm down until the disc just touches the print pad.
Printer
Button
Lift
Arm
Side to Side
Alignment
Print
Pad
Holding Pins