User guide

Rimage Amigo II

6 110654_F

Maintain the Amigo II

Maintenance schedule

Task Frequency

Once a week. Remove dust from Amigo II and surrounding

work area using a lint-free cloth.

Clean the Amigo II

Upon installation and again if the printed label is not centered

on the disc. Refer to the procedures below for more

information.

Align the printer

 Note: For information on cleaning and maintaining your printer, refer to your Everest Printer

User Guide or PrismPlus! Printer User Guide.

Everest Printer

To align your Everest Printer, refer to the following instructions.

Required tools:

• T 25 Torx screwdriver

• 5/32” Allen wrench

1. To power on the Amigo II, press the Amigo II power switch.

2. Wait until the unit completes the initialization.

# s 1 to 2 minutes to complete the initialization. Tip: The Everest II Printer take

3. Prepare the unit for alignment.

a. Manually move the lift arm to the top

of the Amigo II.

b. To place a disc in the lift arm, press

the disc up into the Lift Arm while

pressing the disc release button.

c. To open the print drawer, press the

printer button.

d. Close and re-open the door of the

Amigo II. This releases the lift arm so

you can manually move it.

Lift

Arm

Gri

Disc Release Button