70-920 70-913 Universal Mini Lathe Stand & Extension Stand Shown with Optional Extension Assembly Instructions Record the date of purchase in your manual for future reference. Date of purchase: _________________________ For technical support or parts questions, email techsupport@rikontools.com or call toll free at (877)884-5167 70-920M2 www.rikontools.
TABLE OF CONTENTS Specifications.............................................................................................................................................2 Unpacking and Contents..............................................................................................................................3 Assembling the Base to the Column....................................................................................................................
CONTENTS OF PACKAGE Unpacking and Checking Contents Unpack your lathe stand from its carton and check to see that you have all of the following items. Do not use this stand if any of these items are missing. You may cause injury to yourself or damage to your machine. Carton Contents 70-920 70-913 Qty Item Description Qty 1 A Base & Foot Assembly............................2 1 B Column............................................2 1 C Extension Support (Inside)................
ASSEMBLY Assembling the Base to the Column 1. Locate one Base (Part #14) and one Column (#5). 2. Install two Hex Bolts (#18) and two Washers (#10) through the column’s lower flange and into the Base. 3. Add two Washers (#10) and two Hex Nuts (#9) to the bolts underneath the base, to secure the column in place. FIG. 1. 4. Repeat steps 1-3 to complete the second Base and Column assembly. FIG. 1 Installing the Extension Supports to the Base and Column Assembly 1.
ASSEMBLY Connecting and Adjusting the Extension Supports A 1. Slip the Inside Extension Support bracket (#6) into the Outside Extension Support bracket (#8). 2. Add two Bolts (#7) to the welded hex Nuts that are located on the Outside Extension Support bracket (#8). FIG. 4, A. A 3. Only hand-tighten the nuts at this point. Secure the nuts after the length of the mini-lathe has been determined. See page 6. FIG. 4 ADJUSTMENTS Determining the Proper Lathe Height 1.
ADJUSTMENTS Adjusting for Lathe Length The 70-920 Lathe Stand can be adjusted in length to support a variety of makes, models and lengths of mini and midi lathes. See page 2 for information on the expansion lengths of the stand. 1. Measure the length of your lathe from center of one bolt hole, to the center of the other bolt hole. 2. Loosen the two locking Bolts (#7) on the Outside Extension Support (#8).
ASSEMBLY Optional Stand Extension 70-913 Installing the Optional Lathe Stand Extension The Lathe Stand Extension is typically used to support a lathe that has been elongated with a bed extension. However, it has a variety of other uses such as supporting an accessory table (not included) to hold turning tools, sandpaper, finishing materials, a grinder or sharpening system. 1. Start assembling the Stand Extension by repeating the steps in “Assembling the Base to the Column” located on page 4. 2.
PARTS DIAGRAM for the 70-920 and 70-913 1 70-920 UNIVERSAL MINI LATHE STAND 2 3 4 70-913 MINI LATHE STAND EXTENSION 5 9 6 10 18 18 10 7 9 8 9 10 18 11 12 13 14 15 17 2 16 NOTE: Please reference the Manufacturer’s Part Number when calling for Replacement Parts. For Parts under Warranty, the Serial Number of your machine is required. PARTS LIST for the 70-920 and 70-913 KEY NO. 1 2 3 4 5 6 7 8 9 DESCRIPTION MFG. PART NO.
