Owners manual

THE SANDER MUST NOT BE PLUGGED IN AND THE POWER SWITCH

MUST BE IN THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.

GETTING TO KNOW YOUR SANDER

ASSEMBLY

Item Description

A. Sanding Belt 1” x 42”

B. Sanding Belt Tracking Knob

C. Sanding Belt Table

D. Sanding Belt Table Lock Handle

E. Rubber Machine Feet

F. ON/OFF Safety Switch

G. Motor V-Belt Safety Cover

H. Sanding Disc 8” PSA

I. Miter Gauge

J. Sanding Disc Table

Item Description

K. Sanding Disc Table Lock Handle

L. Sanding Disc Dust Port

M. Sanding Disc Table Angle Scale

N. Motor

O. Motor Capacitor

P. Sanding Belt Dust Port

Q. Sanding Belt Platen

R. Sanding Belt Safety Cover

S. Holder for Hex Wrenches

T. Holder for Miter Gauge

Tools Required for Assembly:

#2 Phillips Screwdriver

Unpacking and Clean-up

1. Carefully remove all contents from the shipping carton. Compare the contents with the list of

contents to make sure that all of the items are accounted for, before discarding any packing material.

Place parts on a protected surface for easy identication and assembly. If any parts are missing or

broken, please call RIKON Customer Service (877- 884-5167) as soon as possible for replacements.

DO NOT turn your machine ON if any of these items are missing. You may cause injury to yourself or

damage to the machine.

2. Report any shipping damage to your local distributor.

3. Clean all rust protected surfaces with ordinary house hold type grease or spot remover. Do not

use; gasoline, paint thinner, mineral spirits, etc. These may damage painted surfaces.

4. Apply a coat of paste wax to the table to prevent rust. Wipe all parts thoroughly with a clean dry

cloth.

5. Set packing material and shipping carton aside. Do not discard until the machine has been set up

and is running properly.