Owners manual

ASSEMBLY

STAND ASSEMBLY

1. Connect leg (#5) with the upper long bar (#1)

with two nuts and bolts (#6 & 7). FIG. 1.

2. Connect another leg (#5) to the other end of

the upper long bar (#1) in step 1. FIG. 2.

3. Assemble the lower long bar (#3) to the pair of legs with

nuts and bolts. FIG. 3. This completes the assembly of one

side of the stand.

4. Repeat steps 1-3 to assemble a second side of the stand.

5. Connect the two sides of the stand together. Assemble

the lower short bar (#4) and the upper short bar (#2) to the

long legs. FIG. 4.

6. Repeat step 5 to assemble the remaining side of the

stand. Assemble the lower short bar (#4) and the upper short

bar (#2) to the long legs.

7. With the stand assembled, t the four rubber foot pads (#8).

FIG. 5.

8. Screws, washers and nuts (#9, 10, 11) are supplied to

nally mount the sander onto the stand for use.

FIG. 1 FIG. 2

FIG. 3

FIG. 4 FIG. 5

FIG. 4