Owners manual

Switch
Plug
Earth Earth
Terminal
Terminal
White
White
Black
Black
White
White
Run
Capacitor
Start
Capacitor
RedBlue
Blue
50-122 Wireing V2
Provide by Wang
Check by Jack
June/30/2014
Motor
19
This machine must be grounded. Replacement of the power supply cable
should only be done by a qualied electrician.
WIRING DIAGRAM
MAINTENANCE
Turn the power switch “OFF” and disconnect the plug from the outlet prior to adjusting or
maintaining the sander. DO NOT attempt to repair or maintain the electrical components of the motor. Take the
sander to a qualied service technician for this type of maintenance.
MAINTENANCE REQUIRED FREQUENCY
1. Check the power cord and plug for any damage. Before each use.
2. Check sanding belts and discs for damage or wear. Before each use.
3. Check all guards and hardware to make sure they are secure. Before each use.
4. Check all moving parts for alignment and binding issues. Before each use.
4. Dress/Clean sanding surfaces for best abrasive action. As needed
5. Replace sanding belts or discs when worn or damaged. As needed.
6. Clean and vacuum dust from the motor housing and other sander parts. As needed.
7. Keep iron tables free of rust. Apply coat of paste wax or silicon spray. As needed.
NOTE: Lubrication of the bearings is not necessary, as they are sealed and pre-lubricated for life. Just replace
a bearing if failure occurs. Do not use compressed air near bearings. Simply wipe the exposed bearing
surfaces with a dry cloth to clean them.
WARNING: If blowing sawdust, wear proper eye protection to prevent debris from blowing into eyes.
Service beyond recommended maintenance on these tools should only be performed by an
authorized, qualied technician.
This tool is intended for use on a circuit that
has a 120 volt electrical receptacle.
The illustration on page 5 shows the type
of the 120v, 3-wire electrical plug and
electrical receptacle that has a grounding
conductor that is required.