Owners manual

ADJUSTMENTS

THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH

MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.

FIG. 20

FIG. 19

REPLACING THE V-BELT

CONTINUED FROM PAGE 13

NOTE: Replacing the V-Belt requires that the Belt

Cover, bottom Base Cover, and whole Sanding Disc

Assembly be removed in order to gain access to the

drive shafts and pulleys.

1. Remove the Belt Cover (Part #39) by unscrewing

the two hex head Screws (#112). FIG. 18.

2. Remove the complete Sanding Disc Table Assem-

bly from the Disc Frame. FIG. 19.

NOTE: Reverse the assembly steps for installing the

Sanding Disc Table that are detailed on pages 10 &

11.

3. Remove the lower Disc Guard (#95) by unscrew-

ing the six Phillips head Screws (#33), and also the

Sandpaper from the metal Sanding Disc. FIG. 20.

4. Remove the metal Sanding Disc (#100). Turn the

center Screw (#98) clockwise to remove it. Pull the

large Washer (#99) from the disc center and then pull

the disc off from the Drive Shaft (#24). Note that the

disc is positioned on the shaft with a small Key (#11).

FIG. 21.

5. Remove the Dust Connection Pipe (#102) from the

lower section of the Disc Frame with the four Phillips

head Screws (#33). FIG. 21.

FIG. 18

FIG. 21