Owners manual
11
ASSEMBLY
FIG. 10
FIG. 9
ADJUSTMENTS
FIG. 8
9. Insert the steel rod (from step 5) through the lower
hole in the right side of the frame. FIG. 8A. The rod
should extend under the table to the other end of the
frame, where it should exit through the large hole in
the left frame. FIG. 8B.
9. Insert the Table Adjustment Handle Assembly
(steps 3 & 4) onto the metal rod, and slide its geared
end through support plate and into the large hole of
the frame’s left side. The gears in the handle end
should align with the teeth in the left support. FIG. 9.
10. Attach the wing Knob (#111) onto the threaded
end of the rod to complete the handle assembly.
NOTE: By loosening the knob, the table angle can be
adjusted by rotating the handle. To lock the table in
position, tighten the knob until the table is secure.
11. The sander’s assembly is complete, and the ma-
chine can be mounted onto the steel stand, table etc.
with bolts or screws (not provided).
A B
Before plugging in and turning on
the machine, complete all of the adjustments in the in-
structions that follow. This will ensure that the sander
is correctly set up for safe and efcient operation.
DISC TABLE ADJUSTMENTS
Ensure sander is disconnected from the power supply
prior to commencing work.
1. To check the trueness of the 90º angle of the disc
sanding table, place a square or other measuring
device on the table with the other end against the
sanding disc. FIG. 10.
2. Loosen the disc table adjustment handle (#111),
and adjust table angle to 90º.
3. Re-tighten the disc table adjustment handle.
4. Adjust the Angle Scale Pointer (#103) to 0°.
5. To adjust the disc table to another angle, loosen the
disc table adjustment handle.
6. Set the table at the desired angle using the angle
scale pointer.
7. Re-tighten the disc table adjustment handle.
CONTINUED ON PAGE 12