Owners manual

ASSEMBLY

COVER

RAILS

INSTALLING THE HANDWHEEL KNOB for Height Setting of the Thickness Table

1. Remove the depth adjustment handwheel by loosening the screw (A), with the supplied 4mm hex wrench.

FIG. 1.

2. Install the knob (B) onto the handwheel with the supplied screw (C).

3. Re-attach the handwheel to the planer side and tighten it back in place with the screw (A).

FIG. 1

INSTALLING THE DUST PORT

1. From the back of the machine, locate the dust port

on the cutterhead assembly. Remove the knobs (A)

by turning each counterclockwise. FIG. 2.

2. Align the dust port over the holes on the top of the

cutterhead assembly, and replace the dust port knobs

by turning them clockwise.

3. To minimize sawdust accumulation on your work-

piece, attach either a 2-1/2 in. or a 4 in. vacuum hose

to the dust port end.

NOTE: The dust chute cap is reversible for this

purpose. Depending on what size vacuum hose is

used, the dust cap can be moved from one end of the

dust port to the other to close the opposite end hole.

COVER

RAILS

FIG. 2

DUST PORT