Owners manual

11
ADJUSTMENTS
REPLANING
using the REPEAT CUT
1. Remove the screws to take
off the handwheel (1 screw),
right side panel (4 screws) and
top cover (4 screws). FIG. 5.
2. Lower the cutterhead assem-
bly until the stop screw stops on
the step block.
3. Plane a scrap piece of wood,
then measure the thickness of
the  nished piece. It should be
the same as the thickness scale
and repeat cut indicator.
4. If an adjustment is neces-
sary, use a wrench to loosen
the lock nut and adjust the stop
screw to correct the height.
5. Once the adjustment is
made, retighten the lock nut and
the stop screw securely.
THICKNESS SCALE ADJUSTMENT
Located on the right front of the planer, the thickness scale
shows the depth of the  nished workpiece.
Inaccurate cuts can be prevented by routinely checking the
alignment of the thickness scale.
1. Table extensions must be level with planer table.
2. Plane a scrap piece of wood, then measure the thickness of
the  nished piece.
3. If properly adjusted, the thickness of the  nished piece
should be the same as indicated on the scale.
4. If out of adjustment, loosen the two screws holding the
scale indicator and adjust the scale indicator, up or down, to
point to the correct setting on the scale.
5. Retighten the two scale indicator screws securely.
THICKNESS
SCALE
SCALE
INDICATOR
& SCREWS
6. Install the right side panel, top cover and
handwheel back onto the planer.
FIG. 5
FIG. 6
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ALL ADJUSTMENTS ARE
COMPLETE.
LOCK
NUT
STOP
SCREW
HANDWHEEL
REPEAT CUT
INDICATOR
STEP BLOCK
STEP
BLOCK