Technical data

ENGLISH
Switching the fire
out of automatic running
(timed operation or manual)
If the „LA“ output is switched to „OFF“
when the fire is switched off (see Heating
Output, Cleaning Cycle Programming,
Page 15), then when in timed operation the
fire is switched off as described in the func-
tions above. The display flashes the follo-
wing alternately:
a) TM Time with xx% heating output or
b) to d) remain identical
After completing the switch off procedure
the display will show the following:
TM Time with OFF
The fire is reactivated after a new start
phase has been completed, as soon as the
next programmed heating period begins.
If the „ON/OFF“ key is pushed during auto-
matic operation, the fire will immediately
go into the shutdown run. The display
flashes alternately:
a) TM Time with xx% heating output or
b) to d) remain the same
After the shutdown phase is complete the
display will show the following:
TM Time with OFF
The fire is reactivated by running through a
new start phase, as soon as the next pro-
grammed heating period begins.
aSwitching off using the operating mode
change in standby
Change from „Manual Operation“ as well
as from Automatic into Standby Mode by
pressing „ENTER“, this switches the fire off
using the procedure described above. After
completing the switch off programme the
display shows „SB“.
To restart the relevant mode must be
selected or the fire started using the re-
mote function (Telephone Start).
External control unit
with room temperature probe
(Pellet-Control-Optional)
The external control unit can be used to
extend your Pellet Fire with Room
Temperature Control Function. To do this
the room temperature is measured using a
sensor in the external control unit.
This function is not part of the standard
scope of supply and can be retrofitted if
required. The relevant extended functions
of the fire and the programming of the
system values are included in the retrofit-
ting kit.
17