Technical data

7. OPERATION
IT IS VITAL THAT THE FIRE PAINTWORK IS
BAKED OUT.
Please follow the following advice when using
the fire for the first few times:
- No children are allowed in the room whilst
this is taking place, as vapours escaping
could be a danger to health.
Adults should also avoid staying in the room
for a longer period of time.
- Do not touch the surface during heating as
it is still soft.
- Ventilate the house several times to remove
the vapours that have been released.
- Heat the fire up to hot - this shortens the
heating and hardening time.
- Hardening the surface is completed after
several heating procedures.
14
The fire must only be started when fully fitted.
Your pellet fire is exclusively approved for
burning pellets made from controlled quality
wood.
Burning non pelletised solid fuels (straw,
maize etc.) is not allowed. Failure to comply
with these specifications invalidates all gua-
rantees and could influence the security of
the fire.
When your pellet fire is operated correctly it
cannot overheat. However continuous heating
at high capacity can shorten the life expec-
tancy of the fire components (fan, motors
and electric control) and is not recommended.
BASIC INFORMATION
ENGLISH
CONTROL AND INTERNAL
CONTROL UNIT - FUNCTION
(Fig. 4, Part 20)
The pellet fire is fitted with a modern pro-
grammable microprocessor control.
The user can preset the individual device
functions via the Internal Control Unit
fitted on the rear right side panel (keypad
with operating display).
Adjustments to the control (main board)
and on the control board may only be car-
ried out by a trained specialist or the ser-
vice personnel.
Inappropriate handling of these parts will
lead to loss of guarantee.
Internal Control Unit
All settings and functions can be controlled
via this unit.
Illustr. 1: Internal control unit Key assign-
ment
DISPLAY FIELD:
Displays the operating states in illuminated
letters.
MENU:
Navigation in the menu level
ENTER:
Navigation in the normal display, in the sub-
menus, confirming entries
MINUS/PLUS:
Reducing or increasing values
ON/OFF:
Switching the fire on or off.
See the APPENDIX, page 24) for a graphic
image of the menu drive for the program-
ming levels.
Possible operating ranges
Your pellet fire can be preset in 3 different
operating modes.
➧ Manual operation
➧ Automatic
➧ Standby-mode
Selecting „ENTER“ enables you to change
between the individual operating types.
„MENU“ key
„MINUS“ key
„ON/OFF“ key
Display field
„ENTER“ key
„PLUS“ key