Instruction manual

11
b) Adjustments to the tube length may be required. To check this, move the
cartridge holder left and right to each end of the printer. It should reach both
ends with ease. Check that the tubing is neither too long nor too short. The
tubing should not interfere with the printer data wire nor should it fall down into
the paper support.
c) If required, adjust the tube length by gently pulling the silicon tubing in the
direction required.
PLEASE DON’T HAVE THE TUBING FITTED TOO TIGHTLY!
d) Peel off the backing tape to the tube connection and place it as pictured below.
Once again please ensure not to twist or bend the tubing.
e) Place a small piece of blue-tac on the printer lid sensor button.
Printer lid
sensor button