Instruction manual

10
b) Remove the orange cartridge cover from each of your new cartridges. This is
done by slowly moving the clip in an anticlockwise direction. Beware that
during transit ink may build up in this cap and will release when the cover is
removed. (i)
(i) (ii)
c) Insert the new cartridges into your printer. Please ensure that the cartridges are
placed in the correct coloured cartridge holder. (ii)
4)
Tube set up
a) Remove the backing tape on the metal tube arm and place it approximately 5
cm from the rear as shown below.
*Please be careful not to twist the tubing before connecting it to the printer.
5-6cm