Instruction manual

3) Attaching Cartridge Chips – Applies to un-chipped units only

If you have purchased a pre chipped unit please proceed to section 4) on page 10.

In order for your cartridges to be recognised by your canon printer, you must

remove the chips from your original cartridges and transfer them onto the CISS

cartridges. Please follow the following steps carefully

a) Turn on your printer and open the cover. The cartridge holder will move to the

cartridge change position. Remove power cable from the back of your printer.

Remove the cartridges from the printer.

b) Using a Stanley knife or sharp blade remove the two plastic lugs which hold the

chip in place. The chips are colour specific so ensure you do not mix them up

as they will not work if they are attached to the incorrect CISS cartridge.

c) Gently lift the chip from the cartridge. Never pry off the chip particularly from

the top of the chip as you may damage the sensitive electronics on the rear