Instruction manual

7
2) Preparing your new CISS for installation
Please ensure the following are present with your CISS.
(1) Air filters x5
(2) Silicone nozzle seal x 5
(3) Cable ties (spare)
(4) Double sided tape tabs (spare)
(5) Syringe and needle
(6) Spare elbow joints and connections
(7) 3 x S shaped clips (for use in MP& MX printers only)
b) Remove your CISS from the box and check the there are no leakages or
cracks and that the silicone tubing is not damaged.
c) Inspect the silicone tubing for air pockets.
d) Close the tube clamp located on the side of the CISS by rolling the roller down
to squeeze the silicone tubing which will prevent ink flow.
1
2
4
5
3
If you have an excessive amount (5cm or
more) of air in the tubing, you will need to
prime the unit. Please refer to page 25 of
this installation manual.
This will prevent any problems with your print
quality further down the track.
If you do not close this valve,
ink will flow back into the
reservoir from your
cartridges.
6
Clamp the tubing
by rolling the roller
down