Instruction manual

22
11) Finishing Touches
a) Place the CISS unit on the right hand side of your printer and Insert all the air
filters into the top of each air balance chamber. The larger end should be
inserted into the air balance chamber.
b) Release the tube clamp on the front of the CISS by rolling it up.
Reinsert power cable to the rear of your printer and perform a head clean and
nozzle check as per steps 1)1)a) and 1)b) on page 5. Please note that this may
need to be performed several times to ensure excess air is removed from the
lines.
CAUTION
DO NOT HAVE THE INK RESERVOIRS HIGHER OR LOWER THAN
THE PRINTER HEIGHT. THIS WILL EFFECT THE INK FLOW TO YOUR
PRINTER, AND MAY CAUSE YOUR PRINTER TO FLOOD WITH INK
Release the tube
clamp by rolling
the roller up.