Instruction manual

19
e) Adjustments to the tube length may be required. With the cartridges in the
change position, remove the power cable from the back of the printer. Slide the
cartridge holder to the left and right ends. It should reach both ends with ease.
Check the tubing is neither too loose nor too taught. The tubing should not
interfere with the data wire or fall into the paper support.
f) Place the filer plug from the empty ink tank into the printer lid sensor button.
g) Included in the packaging you will find another single clip similar to the one
removed from your metal tube arm. Please place each of these clips as located
below. Additional tape will also be found in your pack if required.
Please refer to section 11) Finishing Touches on page 22 to complete
the installation process.
Printer
lid
sensor
button
DON’T HAVE THE TUBING
FITTED TOO TIGHTLY!