Instruction manual

9) Tube set up (MP810 Series Only)

b) Remove the plastic clip located on the end of the metal tube arm. Please retain

this clip as it is required later. The clip will remove by simply twisting it

clockwise. Replace the double sided tape on the metal tube arm with a spare

piece provided in your kit.

c) Attach the metal tube arm on the left hand side of the printer just above the

angle moulding. Ensure the tubing is not twisted between the arm and the

cartridges.

d) Place the plastic clip that is situated on the tubing on the opposite side of the

printer but this time above the dip in the moulding. Place the tubing up and out

the side of the printer as shown.

Plastic

Tubing

Cli