Instruction manual

17
f) Using the large clips included in the accessories package place a piece of
double sided tape on one of the sides and attach the clips in the printer as
pictured below so as that the tubing will not be crimped when the lid closes.
One clip should be positioned on each side.
g) Push the filer plug from the empty ink tank into the printer lid sensor button.
In some models it may be better to cut the ‘pull handle’ off the plug and insert it
into the sensor switch hole upside down.
Please refer to section 11) Finishing Touches on page 22 to complete
the installation process.
CAUTION
DO NOT HAVE THE INK RESERVOIRS HIGHER OR LOWER THAN
THE PRINTER HEIGHT. THIS WILL EFFECT THE INK FLOW TO YOUR
PRINTER, AND MAY CAUSE YOUR PRINTER TO FLOOD WITH INK
Printer lid
sensor
button
Large
Plastic Clip
Left Hand
Side
Right Hand
Side