Instruction manual

a) Attach the metal tube arm (with the plastic clip) on to the left side of the printer

opening. The ideal position of the clip is to place it along the angled edge.

Ensure the tubing is not twisted between the arm and the cartridges.

d) Place the clip that is situated along the tubing on the opposite side of the

printer. When attaching this clip place it in front of the angled edge. The tubing

will run up and out the side of the printer.

e) Adjustments to the tube length may be required. With the cartridges in the

change position, remove the power cable from the back of the printer. Slide the

cartridge holder to the left and right ends. It should reach both ends with ease.

Check the tubing is neither too loose nor too taught. The tubing should not

interfere with the data wire or fall into the paper support.

If required, adjust the tube length by gently pulling the silicone tubing in the

direction required.

PLEASE DON’T HAVE THE TUBING FITTED TOO TIGHTLY!

Plastic Tubing Clip

Printer lid sensor

button

Metal Tube Support Arm