Instruction manual

15
8) Tube set up (MP600 & MP610 Series Only)
a) Included in your accessories package you will find three large S clips. Please
contact Rihac if your accessories package does not contain theses items.
b) Located on the metal tube support arm is a plastic clip. The plastic clip is
attached using double sided tape. Please remove this clip from the support
arm by simply twisting it
c) Attached one of the s clips onto the metal tube arm using a piece of double
sided tape provided. When attaching the clip, place the lip of the clip so that it
will face the rear of the printer when attached. As pictured below.
Plastic clip
Lip of the clip
Lip of the clip
Remove
Plastic Clip