Instructions

Chapter 2 Functions of the Front Panel of GPSA RIGOL
RSA3000E User Guide 2-5
refer to descriptions in "Parameter Setting".
Table 2-3 Stop Frequency
Parameter
Remarks
Default
center frequency+span/2
Range
[1]
0 Hz to Fmax
Unit
GHz, MHz, kHz, Hz
Knob Step
span > 0, step = span/200
span = 0, step = RBW/100
Min = 1 Hz
Left/Right Arrow Key Step
Up/Down Arrow Key Step
CF step
Note
[1]
: The range is from 100 Hz to Fmax in non-zero span.
Freq Offset
You can set a frequency offset value to account for frequency conversions between
the device under test (DUT) and the input terminal of the spectrum analyzer.
Remarks:
 The change of this parameter only changes the display values of the center
frequency, start frequency, and stop frequency; but does not affect any
hardware settings of the spectrum analyzer.
 You can use the numeric keys, the knob, and the arrow keys on the front panel
to modify this parameter; also you can modify it on the touchscreen. For details,
refer to descriptions in "Parameter Setting".
 To eliminate the frequency offset, you can set the frequency offset to 0 Hz.
Table 2-4 Frequency Offset
Parameter
Remarks
Default
0 Hz
Range
-500 GHz to 500 GHz
Unit
GHz, MHz, kHz, Hz
Knob Step
span > 0, step = full span/200
Left/Right Arrow Key Step
Up/Down Arrow Key Step
CF step
CF Step
Changes the step size for the center frequency. Changing the center frequency by a
constant step-size value switches the channel to be measured continuously.
Remarks:
 Set a proper CF step value, and then select the center frequency. Use the