Instructions

Chapter 4 Functions of the Front Panel of EMI RIGOL
RSA3000E User Guide 4-25
 Pk Crit & LIM: performs the search and finds the peak that meets the peak
criteria and limit line criteria.
 SubRng & LIM: performs the search and finds the peak that meets the peak
criteria for each subrange and limit line criteria. After this mode is selected,
the whole span is divided into n subranges. Wherein, n is set by the
Subrange Num menu.
15. Peak Num State
Enables or disables the setting of the number of peaks.
16. Peak Num
When the search criteria is "Peak Criteria" or "Pk Crit & LIM", set the maximum
number of peaks searched.
17. Subrange Num
Sets the number of subranges for the signal search.
Scan Table
Sets the parameters for 10 ranges in the scan table.
Note: The scan table currently displayed on the screen can be saved to the internal
or external memory. If needed, you can recall it at any time. Press Save to save it
according to descriptions in "Save". If a scan sequence is currently executed, then
the Scan Table menu is grayed out and disabled.
1. Select Range
Specifies the selected range. 10 ranges are available for you to choose.
2. Range
Enables or disables the selected scan range. When enabled, the selected range
will be chosen as a part of the measurement. Besides, you can tap the checkbox
at the left side of the selected range in the pre-scan setting table. If the
checkbox is highlighted and with a tick "√" being displayed, it indicates that the
selected range is enabled.
3. Start Freq
Sets the start frequency of the selected scan range.
4. Stop Freq
Sets the stop frequency of the selected scan range.
5. Points
Sets the number of scan points for the selected scan range.