Instructions

RIGOL Chapter 2 Command Systems for GPSA and RTSA Modes
2-140 RSA3000E Programming Guide
Example
The following command sets the average mode to Repeat.
:SENSe:EBWidth:AVERage:TCONtrol REPeat
The following query returns REP.
:SENSe:EBWidth:AVERage:TCONtrol?
[:SENSe]:EBWidth:FREQuency:SPAN
Syntax
[:SENSe]:EBWidth:FREQuency:SPAN <freq>
[:SENSe]:EBWidth:FREQuency:SPAN?
Description
Sets the span of the emission bandwidth measurement.
Queries the span of the emission bandwidth measurement.
Parameter
Name
Type
Range
Default
<freq>
Consecutive Real Number
10 Hz to 3 GHz
2 MHz
Remarks
This command is only valid when the emission bandwidth measurement in GPSA mode is enabled.
This setting changes the span of the analyzer.
Return Format
The query returns the span in scientific notation. Its unit is Hz.
Example
The following command sets the span to 10 MHz.
:SENSe:EBWidth:FREQuency:SPAN 10000000
The following query returns 1.000000000e+07.
:SENSe:EBWidth:FREQuency:SPAN?
[:SENSe]:EBWidth:MAXHold:STATe
Syntax
[:SENSe]:EBWidth:MAXHold:STATe OFF|ON|0|1
[:SENSe]:EBWidth:MAXHold:STATe?
Description
Enables or disables the EBW Max Hold.
Queries the status of the EBW Max Hold.
Parameter
Name
Type
Range
Default
——
Bool
OFF|ON|0|1
OFF|0
Remarks
This command is only valid when the emission bandwidth measurement in GPSA mode is enabled.
When Max Hold is enabled, each measurement result is compared with the previous result, and then display