Instructions

Chapter 2 Command Systems for GPSA and RTSA Modes RIGOL
RSA3000E Programming Guide 2-1
Chapter 2 Command Systems for GPSA and RTSA
Modes
This chapter introduces the commands of the RSA3000E series spectrum analyzer.
Contents in this chapter:
 :CALCulate Commands
 :CALibration Commands
 :CONFigure Commands
 :COUPle Commands
 :DISPlay Commands
 :FETCh Commands
 :FORMat Commands
 IEEE 488.2 Common Commands
 :INITiate Commands
 :INSTrument Commands
 :MMEMory Commands
 :OUTPut Command
 :READ Commands
 [:SENSe] Commands
 :SOURce Commands
 :STATus Commands
 :SYSTem Commands
 :TRACe Commands
 :TRIGger Commands
 :UNIT Command
Remarks:
1. The commands concerning the advanced measurement are only available for the RSA3000E model
installed with relevant options. For details, refer to remarks for each command subsystem.
2. The commands related to the tracking generator are only available for RSA3030E-TG/RSA3015E-TG.
They are only available for GPSA mode.
3. For the command set, unless otherwise specified, the query command returns "N/A" (without
quotations in its return format) if no specified option is installed. If the queried function is disabled or
improper type match is found, the query command will return "Error" (without quotations in its return
format).
4. This manual takes RSA3030E as an example to illustrate the range of the parameters in each
command.