Instructions

Chapter 2 Command Systems for GPSA and RTSA Modes RIGOL
RSA3000E Programming Guide 2-129
The following query returns 1000000.
:SENSe:CNRatio:BANDwidth:NOISe?
[:SENSe]:CNRatio:OFFSet
Syntax
[:SENSe]:CNRatio:OFFSet <freq>
[:SENSe]:CNRatio:OFFSet?
Description
Sets the center frequency difference (offset frequency) between the carrier waveform and the noise.
Queries the offset frequency.
Parameter
Name
Type
Range
Default
<freq>
Consecutive Real Number
3 Hz to 1 GHz
2 MHz
Remarks
This command is only valid when the C/N ratio measurement in GPSA mode is enabled.
Return Format
The query returns the offset frequency in integer. Its unit is Hz.
Example
The following command sets the offset frequency to 1 MHz.
:SENSe:CNRatio:OFFSet 1000000
The following query returns 1000000.
:SENSe:CNRatio:OFFSet?
[:SENSe]:CORRection:CSET:ALL:DELete
Syntax
[:SENSe]:CORRection:CSET:ALL:DELete
Description
Deletes all the amplitude correction data.
Remarks
This command is only available for GPSA mode.
[:SENSe]:CORRection:CSET:ALL[:STATe]
Syntax
[:SENSe]:CORRection:CSET:ALL[:STATe] OFF|ON|0|1
[:SENSe]:CORRection:CSET:ALL[:STATe]?
Description
Enables or disables all the amplitude correction functions.
Queries the status of the amplitude correction function.