Information

RSAxxx(N) EMI Mode – Getting Started
RIGOL Technologies CO., LTD. 09.09.2021
Figure 8: Result of measurement after finalization of test with the settings described above
 Therefore you must select separately the dynamic range of the measurement meter as follow:
Please select [AMPT] and adjust attenuator and pre-amplifier / reference level according to your
need (see figure 7).
Correction:
In case you using external components like attenuators, amplifiers, cable, LISN, etc. you can add a
correction which will be take into account into the result of trace, measurement meter and signal table.
 To insert correction, please select [Input Output] and [Corrections]
Start The Measurement:
After you finalized all the setup of your need, you can start the test.
 Please select [Sweep]  [Start]
Signal Table Settings:
 Signal table displays all the peaks which are detected in the trace according to your adjusted search
criteria.
 The numbers of detected peaks can be adjusted in the signal table as follow: Select [Meas Setup]
 [Signal Table] and insert the settings for search criteria and sort of signals according to your
need.
 You can also select one peak and [Zoom In] for deeper analysis.