Instructions

Chapter 2 Functions of the Front Panel of GPSA RIGOL
RSA3000E User Guide 2-87
Corrections
Sets the parameters related to the amplitude correction to compensate for the gain
or loss from external devices such as Antenna and Cable. When using this function,
you can view the correction data table and save or load the current correction data.
Select
Selects a correction factor from Antenna, Cable, Other, or User. By default, all the
correction factors are disabled. After selecting a correction factor, press Correction
to enable the correction factor. RSA allows users to enable multiple correction factors
at the same time.
Correction
Sets the on/off status of the amplitude correction. By default, it is off. If enabled, the
currently selected correction factor data will be used for amplitude correction. If
multiple correction factors are enabled, all the corresponding data will be used for
amplitude correction.
Freq Interp
Sets the interpolation type of the points between two points in the correction table
during amplitude correction.
 In Lin mode, linear interpolation is adopted for the frequency, and log
interpolation is adopted for the amplitude.
 In Log mode, for both of frequency and amplitude, we interpolate on a log scale.
Edit
Press this key to enter the correction data editing interface. You can edit the
frequency of the correction factor and the correction data of the corresponding
amplitude.
1. Navigation: Selects the first line of the correction data table.
2. Frequency: Edits the frequency of the currently selected point.
3. Amplitude: Edits the amplitude correction value of the currently selected point.
4. Append Point: Inserts an edit point and adds a line to the correction table.
5. Delete Point: Deletes the currently selected point and deletes a line from the
correction table.
Note: The edited correction data can be saved to the internal or external memory of