Instructions

RIGOL Chapter 2 Functions of the Front Panel of GPSA
2-50 RSA3000E User Guide
2. Avg Mode
Sets the average mode to "Exponential" or "Repeat". The default average mode
is "Exponential".
 When "Exponential" is selected, the result is the exponential average of the
measurement results obtained in the past N times (N is specified in "Avg
Number").
 When "Repeat" is selected, the result is the arithmetic average of the
measurement results obtained in the past N times (N is specified in "Avg
Number").
3. Avg State
Selects whether to averaging the measurement results. By default, it is set to
"On".
4. Edit Channel
1) Channel Sheet
Opens or closes the channel editing table. When you select "On", the screen
is split into two sections. The left section displays a channel editing table,
and the right section displays the traces.
2) Navigations
Selects the first line of the channel editing table.
Note that when you select "Off" under Channel Sheet, this menu is
invalid.
3) Channel Frequency
 In the channel editing table, when a channel is selected, this menu
displays the center frequency of the selected channel. If you modify
the frequency at this time, the center frequency of the corresponding
selected channel will be updated at the same time.
 When no channel is selected in the channel editing table, this menu
displays the center frequency of the last selected channel. At this time,
you can set the center frequency of the channel according to your
needs, and then press Add Channel to add a channel.
4) Channel Span
Sets the frequency width of the channel to be tested, and the power of the
channel is the power integral within this bandwidth. You can use the
numeric keys, the knob, or arrow keys to modify this parameter; you can
also use the touch screen to modify the parameter.
 In the channel editing table, when a channel is selected, this menu
displays the channel span of the selected channel. If you modify the
span at this time, the span of the corresponding selected channel will
be updated at the same time.
 When no channel is selected in the channel editing table, this menu
displays the span of the last selected channel. At this time, you can set