Data Sheet

11
RIGOL
Hardware Pass/Fail Test
Enhanced FFT Analysis
The MSO7000/DS7000 series is equipped with hardware
pass/fail test function as the standard configuration, which
can be used in signal monitoring for a long time, signal
monitoring during design, and signal test in the production
line. You can set the test mask based on the known
"standard" waveform, and then compare the signal under
test with the "standard" waveform to display the statistics on
the test results. When a successful or failed test is detected
by the oscilloscope, you can choose to immediately stop
monitoring, enable the beeper to sound an alarm, or save
the current screen image. Also, you can choose to continue
monitoring.
The MSO7000/DS7000 series can analyze 1 Mpts of FFTs,
which improves the frequency resolution to a large extent,
convenient for you to better analyze the disturbance noise in
the circuit under test. To adjust the spectrum waveforms to
be observed, set the center frequency and the span; or set
the start frequency and the stop frequency. The MSO7000/
DS7000 series also provides the peak search function, which
can auto mark up to 15 peaks and display their frequencies
and amplitudes in the form of a list. Such information and
the non-peak section in the frequency-domain cursor
measurement can greatly improve the working efficiency of
the engineers.