Data Sheet

19
RIGOL
Input Impedance About 101 kΩ
Probe Load ≈8 pF
Vertical Resolution 1 bit
Horizontal System--Analog Channel
Horizontal System--Analog Channel
Range of Time Base
70 MHz 100 MHz 200 MHz 350 MHz
5 ns/div~1 ks/div 5 ns/div~1 ks/div 2 ns/div~1 ks/div 1 ns/div~1 ks/div
Support fine adjustment
Time Base Resolution 10 ps
Time Base Accuracy ±10 ppm ± 10 ppm/year
Time Base
Delay Range
before
triggering
≥1/2 screen width
after
triggering
1 s or 100 div, whichever is greater
Time Interval (△T)
Measurement
±(1 sample interval) ± (2 ppm×readout)±50 ps
Inter-channel Offset
Correction Range
±100 ns
Horizontal
Mode
YT Default
XY X = Channel 1, Y = Channel 2
SCAN Time base ≥200 ms/div, available to enter or exit the SCAN mode by rotating the Horizontal SCALE knob
ROLL
Time base ≥200 ms/div, available to enter or exit the ROLL mode by rotating the Horizontal SCALE knob
(enable the auto ROLL mode at first)
Horizontal System--Digital Channel
Horizontal System--Digital Channel
Min. Detectable Pulse Width 5 ns
Maximum Input Frequency
200 MHz (accurately copied as the sine wave of the maximum frequency of the logic square wave;
input amplitude is the minimum swing; the shortest the ground cable is required for the logic probe)
Inter-channel Time Delay 2 ns (typical), 5 ns (maximum)
Acquisition System
Acquisition System
Max. Sample Rate of Analog Channel
MSO5354/MSO5204/MSO5104/MSO5074:
8 GSa/s (single-channel), 4 GSa/s (half-channel
[1]
), 2 GSa/s (all channels)
MSO5102/MSO5072:
8 GSa/s (single-channel), 2 GSa/s (all channels)
Max. Memory
Depth
of Analog Channel
Standard 100 Mpts (single-channel), 50 Mpts (half-channel)
[1]
, 25 Mpts (all channels)
2RL(option) 200 Mpts (single-channel), 100 Mpts (half-channel)
[1]
, 50 Mpts (all channels)
Max. Sample Rate of Digital Channel 1 GSa/s (all channels)
Max. Memory Depth of Digital Channel 25 Mpts (all channels)
Acquisition Mode
Normal Default
Peak Detection Capture 500 ps glitches
Average Mode 2, 4, 8, 16…65536 are available for you to choose, averaging point by point
High Resolution 12 bits (max .)
Trigger System
Trigger System
Trigger Source Analog channel (1~4), digital channel (D0~D15), AC Line
Trigger Mode Auto, Normal, Single
Trigger Coupling
DC DC coupling trigger
AC AC coupling trigger
High
Frequency
Rejection
High frequency rejection, cut-off frequency~55 kHz (internal only)
Low
Frequency
Rejection
Low frequency rejection, cut-off frequency~55 kHz (internal only)
Noise Rejection Increase delay for the trigger circuit (internal only), On/Off
Holdoff Range 8 ns to 10 s
Trigger Bandwidth Analog bandwidth
Trigger Sensitivity
1 div or 5 mVpp, whichever is larger, <10mV/div
0.5 div, ≥10mV/div
Enable the noise rejection, with trigger sensitivity reducing half